Precision hydraulic Deadweight Tester, motorized, (10～400)MPa, 0.01%RD, Sebacate, Tungsten Carbide PCU, 316SS mass set, metric connector with adapters, with temperature indicator
MODEL BL515 HYDRAULIC PRECISION PRESSURE BALANCE
The model BL515 hydraulic precision pressure balance is widely applicable in primary pressure calibration laboratories.
Both the piston and cylinder are manufactured from tungsten carbide. This pairing of materials, in comparison to other materials, has very low pressure and temperature coefficients of expansion, which results in a very good linearity for the effective area of the piston and a very high accuracy. Over-pressure protection is integrated, which prevents the piston from being forced out vertically and avoids damage to the piston-cylinder system in the event of masses removal under pressure.
FEATURE
0.005% and 0.01% accuracy
The accuracy of low limit range keeps same as upper limit range
Tungsten carbide piston and cylinder
Motorized piston rotation function
Built-in thermometer
Dial indicator shows floating piston positon
High quality needle valves provide optimum control and sealing
Optional 280MPa / 40,000 psi is available.
Optional ISO17025 calibration service
APPLICATION
Primary pressure calibration in lab
Precision pressure measurement
PRESSURE SELECTABLE SHEET
Part Number
Pressure Range
Effective Area
Piston and Bell (P/Kg)
Mass Set
KY0.6
( 0.04~0.6 ) MPa
1 cm2
40kPa @ 0.4kg
6 kg
KY6
( 0.1 ~ 6 ) MPa
0.2 cm2
0.1MPa @0.2kg
12 kg
KY25
( 0.5 ~25 ) MPa
0.1 cm2
0.5MPa @0.5kg
25 kg
KY60
( 1 ~ 60 ) MPa
0.05 cm2
1 MPa @0.5kg
30 kg
KY70
( 1 ~ 70 ) MPa
0.05 cm2
1 MPa @0.5kg
35 kg
KY100A
( 2 ~ 100 ) MPa
0.05 cm2
2 MPa @1kg
50 kg
KY100B
( 1 ~ 100 ) MPa
0.05 cm2
1 MPa @0.5kg
50 kg
KY160
( 2 ~ 160 ) MPa
0.05 cm2
2 MPa @1kg
80 kg
KY250A
( 5 ~ 250 ) MPa
0.02 cm2
5 MPa @1kg
50 kg
KY250B
( 2.5~250 ) MPa
0.02 cm2
2.5MPa @0.5kg
50 kg
KY250C
( 2 ~ 250 ) MPa
0.02 cm2
2 MPa @0.4kg
50 kg
SPECIFICATION
Accuracy: 0.01%RD, 0.005%RD
Piston and cylinder material: Tungsten carbide
Mass material: 304 non-magnetic stainless steel
Hydraulic base material: Aluminium Alloy/ Stainless steel
Seal material: Buna-N, FTM, PTFE, Cu Alloy
Medium: Mineral Oil (<25MPa); SEBACATE (≥25MPa)
Pressure units available: MPa, bar, psi (optional)
Connector: Metric, (NPT and BSP is optional)
Thermometer: only for 0.005%
Base dimension: 410 mm (H) x 375 mm (L) x 445 mm (D)
